Reviews Mazda Mazda 6 (Atenza) Sedan 2002 - 2005
Reviews Mazda Mazda 6 (Atenza) Sedan2002 - 2005 Collected from masters and engineers of service stations for an objective assessment of reliability and features of Mazda 6 (Atenza) sedan.
| Engine |  |
There may be problems with the timing chain and the crankcase pallet laying at versions with a 2.3 liter engine. Engine 2.0 gasoline is characterized by increased oil consumption - up to 600 grams per 1000 km. Sometimes the exhaust gas neutralizer (diagnosis of the problem: a reduction in high-speed power, rattling sound from under the hood). If the gas pedal is pressed with the effort, then it is necessary to clean the throttle. |
| Transmission |  |
minimum Repair Cost Problems |
| Control system and suspension | |
The resource of shock absorbers and front suspension levers is about 100 thousand km. Bearings of hubs often wear. |
| Brake system | |
minimum Repair Cost Problems |
| Heated air and air conditioning | |
minimum Repair Cost Problems |
| Start and Charging System | |
minimum Repair Cost Problems |
| Electrical components and other | |
minimum Repair Cost Problems |
| Body stability to corrosion | |
medium problems |
* Information collected from specialists from service stations
|
Minimum Repair Cost Problems |
|
Medium problems |
 |
Serious problems with high repair cost |
your comment
Who will tell, in the morning, when I start the engine, a specific script appears in front of a couple of seconds. The same creak, if the food at a low speed with an immentable engine. Then disappears. What could be the cause? \u003cbr/\u003e
To answerEngine 2.0.
To answerGeorg, the reason in the generator belt either in one of the rollers!
To answerGuys, tell me what shods to buy? I set some, so they whistle .... advise the manufacturer, please! Whose blocks fire ....
To answerI recommend clients usually LPR or REMZA (REMSA), it is Roadhouse, Italy and Spain, just like the finalists of Euro 2012, there were no complaints
To answerNo blocks whistle, but discs. The allowable whistle interval is 800 km., If after that it does not stop, then the discs for replacement. The average mileage of disks under Euro-5 - 30000 / 35000km. The officials do not change the wheels when the run is achieved ... they need it? \u003cbr/\u003e \u003cbr/\u003e If you don't think correctly the question, then the answer is in the forehead - buy cheap pads. They will whistle will be less if they buy very bad - there will not be completely for it to be ceramized in them. \u003cbr/\u003e \u003cbr/\u003e The quality of the pads can only be understood on the dirt on the disks and on the peaks in the brakes, if you try to slow down at 120 ... on the track, for example. So within the framework of the city driving, there will be no difference. \u003cbr/\u003e \u003cbr/\u003e But wheels can not be changed ... well, until they break (they are ventilated)
To answerSurprised, you are me, Tejk. Always thought that the pads whistles and those who whistle, those bad, and who do not whistle are good, but it turns out to be.
To answerPerestali Rabotat 'Steklopod'eMniki S Obshego Pul'ta, Chto Na Voditel'skoj Dveri I Perestali Rabotat' Dovodchiki Stekol. Chto delat '?
To answerIt often happens if the battery is disconnected. Lower the glass (directly by the button on the desired door) to the end, then lift to the end (not releasing the button) and hold it after the lift for a couple more seconds. So on each door. Everything will start working
To answerTaking advantage of the tip-cured !!! Thanks!!!
To answerTell me, the heating of the driver's seat is constantly working when the heating mode is turned off
To answerWhen moving in rolling or on the traffic light, it stalls periodically, the turns are floating. When the movement is all right. Is it possible to temporarily exploit?
To answerThere is vibration at 1000,500 revolutions, single 700 works smoothly. Tell me, can anyone know.
To answerIs there a vibration at idle?
To answerProbably the right question: Is there a vibration at idle during turns of 1000-1500
To answerI would have started checking with candles, it can be trite with these revolutions. I somehow had a similar situation on focus: the engine is OK, the engine works smoothly, with turns from 1000 to 1500, the vibration is under load ... As it turned out, it was stupid in the candles, after their twisting on some electrodes was raised, after the films of the candles , everything is normal! By the way, I recommend putting the candles to put NGK Iridium! They actually save fuel and increase dynamics. In no case is not Bosch (for we have a fake in most of our own, although it looks identical). I somehow purchased Bosch 2 candles in one place, and 2 in another 9th it turned out, marking and candles are identical), after 50 km the engine start sausage. The autopsy showed that two candles practically did not work were in gasoline. I bought 2 more candles in the same place, where and 2 previous normal and everything was good. And, as later recognized from the sellers, it does not matter Bosch Russia or Bosch Germany, fake those and those.
To answerput the iridial and 100 thousand without problems
To answerLooks like a ignition coil.
To answeri changed something shock absorbers, put Lemfoeder, and only enough for 12 thousand km, did LemForder fake?
To answeralas, everyone fake
To answerPutting gas equipment 4 generations on the engine 2.3, 6 months after installation can not be configured - I go on gasoline
To answerdo not ride to fools
To answerI demand a refund of money from them, and they me that the reason in the car, first spoke to change the candles, the coil, and now they say that the compression is low - change the engine! I will submit to court
To answerTell me who knows! Lamp Esp.What is the problem?
To answerIt may turn around simply after a long bounce (you need to reset the error), if it does not help, then by the error number through the computer to determine the faulty module and watch it
To answerThere is a question if someone knows the cooling fan turns on slightly reaching critic. Approximately 110 degrees we have hot, it just good to cool, Tosol starts up in the tank. Especially in traffic jams. If there are considerations advise.
To answerThe fan must work between 95-105 degrees with a good (sealed) cooling system (serviceable valves) and high-quality coolant, boiling should occur at 115-120 degrees. Therefore, it is necessary to check the temperature sensor, then the fan control unit (if there is) and the quality of the antifreeze and the tightness of the cooling system (on a heated engine, the pressure in the system must be redundant - all pipes are inflated)
To answerChange the radiator lid! Perhaps pressure is not in the system
To answerthermostat \u003cbr/\u003e
To answerYes, of course, the thermostat
To answerDo not work feet (all) what to do? Where to begin?
To answerSee frog
To answerWhat is a frog?
To answerThis is such a contact that, when you press the brake pedal closes, and transmits voltage to stop signals according to the chain.
To answerthe starter first twists and then just buzzes what could be the problem?
To answerin the starter, do not twist it ... take it off - and in repair, you may still be repaired. As soon as the starter began turning badly - it can not be twisted, for a complete replacement may be required otherwise
To answerit is most likely bendix
To answerPerhaps Bendix. If the starter works. And then simply scrolls most likely on the Bendix of the teeth of the gear gears!
To answerEats 2 liters of oil for 1000 km, engine 2.3, exhaust is normal. What to watch? Where in Moscow go?
To answerwhen turning to win the gur what's the matter?
To answerIt's time to look for a bu, new Chinese help less help, 30 percent heavier steering wheel turn. Bu somewhere will cost 3000 rubles
To answersoon it will cover \u003cbr/\u003e
To answerdoes not work the door lock to the left in front, I can not remove the door trim for inspection, can someone tell me? O
To answerIf I do not change my memory (about 3 years ago, I filmed the trim), to unscrew the bolt below, then lift the trim up
To answerThe machine heats up 15 min. And the air from the stove is a little warm. There was no such winter in the winter.
To answerThe machine heats up 15 min. And the air from the stove is a little warm. There was no such winter in the winter.
To answer1) either requires replacement of thermostat 2) or little antifreeze
To answerhello everyone, I have a problem already lasting 1 year jumping speeds at idle and with a federation as it is for her ass, someone keeps it, and if the Gas does not set it, it can also stop and stall, candles, armor botanada changed the tweeter and Rough changed, nozzles washed, idling tachika cleaned the damper identity shows a check on the probe lamp and it happens a machine perfectly, the time from time to the machine behaves in mood, then jumping something I don't know the felon on the damper of the electric valve ??? If Cavoto had this and corrected, then tell me it was already fed one and did not start to start the first time with the auto launch as Boto CTOTO Ignition Keyplains The car was laid and the Warring knob!
To answerhello everyone, I have a problem already lasting 1 year jumping speeds at idle and with a federation as it is for her ass, someone keeps it, and if the Gas does not set it, it can also stop and stall, candles, armor botanada changed the tweeter and Rough changed, nozzles washed, idling tachika cleaned the damper identity shows a check on the probe lamp and it happens a machine perfectly, the time from time to the machine behaves in mood, then jumping something I don't know the felon on the damper of the electric valve ??? If Cavoto had this and corrected, then tell me it was already fed one and did not start to start the first time with the auto launch as Boto CTOTO Ignition Keyplains The car was laid and the Warring knob!
To answerdoesn't cover the cover of the chamber. What should I do?
To answertell me the P0757W error, how to find?
To answerHealthy, I can have such a question who came across? When I start a car from under the hood, a creak is distributed, then it is not. I think it is a stretch roller. Who knows what else?
To answerHello everyone. I have a 2005 atenza. The problem is that when I stop at the traffic light after some time there is a sharp jerk of the engine and with it and the whole car with a sharp drop of revolutions and also a sharp drop in a normal position somewhere 500,600 about. What to do tell me.
To answerThe same trouble. Perhaps El.Magn. Valve VIKHR. Zadlok.
To answerTell me how much creaks in the generator area that it can be the bearing on the generator changed not helps.
To answerWhat could be if the engine is warm at temperatures -15
To answer